Aviation Regulations Logo
§ 21.4
ETOPS reporting requirements.
(a) Early ETOPS: reporting, tracking, and resolving problems. The holder of a type certificate for an airplane-engine combination approved using the Early ETOPS method specified in part 25, Appendix K, of this chapter must use a system for reporting, tracking, and resolving each problem resulting in one of the occurrences specified in paragraph (a)(6) of this section.
(1) The system must identify how the type certificate holder will promptly identify problems, report them to the responsible FAA aircraft certification office, and propose a solution to the FAA to resolve each problem. A proposed solution must consist of—
(i) A change in the airplane or engine type design;
(ii) A change in a manufacturing process;
(iii) A change in an operating or maintenance procedure; or
(iv) Any other solution acceptable to the FAA.
(2) For an airplane with more than two engines, the system must be in place for the first 250,000 world fleet engine-hours for the approved airplane-engine combination.
(3) For two-engine airplanes, the system must be in place for the first 250,000 world fleet engine-hours for the approved airplane-engine combination and after that until—
(i) The world fleet 12-month rolling average IFSD rate is at or below the rate required by paragraph (b)(2) of this section; and
(ii) The FAA determines that the rate is stable.
(4) For an airplane-engine combination that is a derivative of an airplane-engine combination previously approved for ETOPS, the system need only address those problems specified in the following table, provided the type certificate holder obtains prior authorization from the FAA:
If the change does not require a new airplane type certificate and . . .
Then the Problem Tracking and Resolution System must address . . .
(i) Requires a new engine type certificate
All problems applicable to the new engine installation, and for the remainder of the airplane, problems in changed systems only.
(ii) Does not require a new engine type certificate
Problems in changed systems only.
(5) The type certificate holder must identify the sources and content of data that it will use for its system. The data must be adequate to evaluate the specific cause of any in-service problem reportable under this section or § 21.3(c) that could affect the safety of ETOPS.
(6) In implementing this system, the type certificate holder must report the following occurrences:
(i) IFSDs, except planned IFSDs performed for flight training.
(ii) For two-engine airplanes, IFSD rates.
(iii) Inability to control an engine or obtain desired thrust or power.
(iv) Precautionary thrust or power reductions.
(v) Degraded ability to start an engine in flight.
(vi) Inadvertent fuel loss or unavailability, or uncorrectable fuel imbalance in flight.
(vii) Turn backs or diversions for failures, malfunctions, or defects associated with an ETOPS group 1 significant system.
(viii) Loss of any power source for an ETOPS group 1 significant system, including any power source designed to provide backup power for that system.
(ix) Any event that would jeopardize the safe flight and landing of the airplane on an ETOPS flight.
(x) Any unscheduled engine removal for a condition that could result in one of the reportable occurrences listed in this paragraph.
(b) Reliability of two-engine airplanes—(1) Reporting of two-engine airplane in-service reliability. The holder of a type certificate for an airplane approved for ETOPS and the holder of a type certificate for an engine installed on an airplane approved for ETOPS must report monthly to their respective FAA type certificate holding office on the reliability of the world fleet of those airplanes and engines. The report provided by both the airplane and engine type certificate holders must address each airplane-engine combination approved for ETOPS. The FAA may approve quarterly reporting if the airplane-engine combination demonstrates an IFSD rate at or below those specified in paragraph (b)(2) of this section for a period acceptable to the FAA. This reporting may be combined with the reporting required by § 21.3. The responsible type certificate holder must investigate any cause of an IFSD resulting from an occurrence attributable to the design of its product and report the results of that investigation to its FAA office responsible for administering its type certificate. Reporting must include:
(i) Engine IFSDs, except planned IFSDs performed for flight training.
(ii) The world fleet 12-month rolling average IFSD rates for all causes, except planned IFSDs performed for flight training.
(iii) ETOPS fleet utilization, including a list of operators, their ETOPS diversion time authority, flight hours, and cycles.
(2) World fleet IFSD rate for two-engine airplanes. The holder of a type certificate for an airplane approved for ETOPS and the holder of a type certificate for an engine installed on an airplane approved for ETOPS must issue service information to the operators of those airplanes and engines, as appropriate, to maintain the world fleet 12-month rolling average IFSD rate at or below the following levels:
(i) A rate of 0.05 per 1,000 world-fleet engine-hours for an airplane-engine combination approved for up to and including 120-minute ETOPS. When all ETOPS operators have complied with the corrective actions required in the configuration, maintenance and procedures (CMP) document as a condition for ETOPS approval, the rate to be maintained is at or below 0.02 per 1,000 world-fleet engine-hours.
(ii) A rate of 0.02 per 1,000 world-fleet engine-hours for an airplane-engine combination approved for up to and including 180-minute ETOPS, including airplane-engine combinations approved for 207-minute ETOPS in the North Pacific operating area under appendix P, section I, paragraph (h), of part 121 of this chapter.
(iii) A rate of 0.01 per 1,000 world-fleet engine-hours for an airplane-engine combination approved for ETOPS beyond 180 minutes, excluding airplane-engine combinations approved for 207-minute ETOPS in the North Pacific operating area under appendix P, section I, paragraph (h), of part 121 of this chapter.
[Doc. No. FAA-2002-6717, 72 FR 1872, Jan. 16, 2007]